The newly purchased glass body wash sub-packaging bottles have their own labels and stickers that are difficult to clean: forcibly tearing them off will always leave stubborn offset printing, and the bottle will become sticky and gray. When the face value is lowered, it will easily get stained with dust and stains. The sub-packaging cleaning products are very unsightly. Ordinary scrubbing cannot remove the adhesive layer at all. Without complex tools, it can be cleaned easily and without traces.
The easiest way to make no traces at home: Use hot air to soften the gel. Use an ordinary hair dryer to turn on the hot air, evenly heat the front and back of the label for 1-2 minutes, and melt the pressure sensitive adhesive on the bottom of the label at high temperature.
After the heating is completed, gently peel off from the corner of the label, and the entire sticker can be completely peeled off without residual glue or scratches. If there is a small amount of offset printing left behind, use a cotton swab dipped in a small amount of cooking oil or baking soda water, and gently rub it for a few seconds.
This method does not damage the glass bottle body or leaves no traces of corrosion, and is suitable for all cleaning and protection glass packaging bottles. After processing, the bottle is clean and transparent, without a sticky feel, and it will be more compliant to apply custom labels later, and the bottle's face value will be directly full.
